Notes On Handling The Touch Unit (Eb-1430Wi Only) - Epson Europe EB-1420Wi Guide D'installation

When turning on the projector, do not look into the projection window.
This could cause damage to eyesight due to the powerful light emitted. Take particular care when
there are children present. When turning on the projector at a distance using the remote control,
make sure there is no one looking into the projection window.
When using the projector, do not place any objects or put your hand near the projection
window.
This area is dangerous as it reaches a high temperature due to the concentrated projection light.
Do not cover the projector's air intake vent or air exhaust vent. If either of the vents are
covered, the internal temperature could rise and cause a fire.
Avoid locations subject to high temperatures, such as close to heaters, and leave a gap of at least
20 cm between the wall and the air exhaust vent.
Do not use the projector in a location subject to combustible or explosive gas.
The projector may catch fire because of the high temperature of the lamp inside the projector.
If any abnormalities occur with this product, immediately disconnect the cables from the
product, and then contact your local dealer or the nearest Epson service call center.
Continuing to use the product in an abnormal condition could cause a fire, electric shock, or visual
impairment.
Do not install this product in a location where the operating temperature for your projector
model may be exceeded.
Such an environment may damage the projector.
Install this product in a place free from excessive dust and humidity to prevent the lens or
optical components from becoming dirty.
Do not use excessive force when adjusting this product.
This product may break, resulting in personal injury.

Notes on handling the Touch Unit (EB-1430Wi only)

Do not disassemble or remodel the Touch Unit.
The Touch Unit contains a high power laser product that could cause a fire, electric shock, or an
accident.
Follow the instructions in this guide to setup and operate the Touch Unit.
If the Touch Unit is not setup and operated correctly, it could cause damage to eyesight due to
light from the laser.
Do not apply optical devices such as a magnifying glass or telescope to the laser light
diffused from the Touch Unit.
Using it in this condition could have a negative influence on the human body. It could also cause
a fire or accident.
Warning
Caution
Warning
3
Using the Product Safely