Installing The Touch Unit; Installation Procedure - Epson Europe EB-1420Wi Guide D'installation

Installation Guide
Installing the Touch Unit (EB-1430Wi only)
Check that the following procedures have been completed before installing the Touch Unit.
• Installing the Projector ( s p.27)
• Adjusting the Projected Image ( s p.40)
• Calibrating the Interactive Pen ( s p.47)
About installation
• There are magnets built into the back of the Touch Unit. Normally, the Touch Unit should be installed by attaching
the magnets to the screen.
• If the magnets cannot be attached to a screen, use commercially available M4 screws (x3).
• Attach the Touch Unit to the same level surface as the screen surface.
• Attach the Touch Unit to a flat, smooth, unwarped surface. If there is unevenness on the screen surface of more than
5 mm, the position of your fingers is not detected, and touch operations may not be performed correctly.

Installation Procedure

Install the Touch Unit, and then connect to the projector.
Caution
Only connect the Touch Unit to the EB-1430Wi. Do not connect it to any other projectors or devices.
a
Turn on the projector, and then press the [Menu] button
Using the Remote Control
b
Select Easy Interactive Function from Extended
Using the Control Panel
56