Reflecting Saved Settings To Other Projectors - Epson Europe EB-1420Wi Guide D'installation

Appendix
c
While holding down the [Esc] button on the remote control or the control panel, connect
the power cord to the projector
The status indicator and the power indicator turn blue, and the lamp indicator and the temperature
indicator turn orange.
When all of the projector's indicators turn on, release the [Esc] button.
When all of the indicators start flashing, the batch setup file is being written.
Caution
•
Do not disconnect the power cord from the projector while the file is being written. If the power cord
is disconnected, the projector may not start correctly.
•
Do not disconnect the USB flash drive from the projector while the file is being written. If the USB flash
drive is disconnected, the projector may not start correctly.
When writing completes normally, the projector turns off, and only the power indicator is lit blue.
When the power turns off, remove the USB flash drive.

Reflecting saved settings to other projectors

a
Disconnect the power cord from the projector, and check that all of the projector's
indicators have turned off
b
Connect the USB flash drive containing the saved batch setup file to the projector's USB-A
port
c
•
Do not connect a USB flash drive to the
•
When the USB flash drive contains 1 to 3 types of batch setup files, the file is reflected to the
projector with the same model number. If there are multiple files for a projector with the same
model number, the settings may not be reflected correctly.
•
When there are four or more types of batch setup files on the USB flash drive, the settings may
not be reflected correctly.
•
Do not store any data except for the batch setup file on the USB flash drive. If the USB flash drive
contains data other than the batch setup file, the settings may not be reflected correctly.
port.
76