DeWalt DCFS950 Guide D'utilisation page 16

English
DCFS9501 Driver Blade Replacement Kit
(Fig. N–P)

WARNING: For your own safety, read the tool
instruction manual before using any accessory.
Failure to heed these warnings may result in serious
personal injury and damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.
NOTICE: All the mechanical parts of the driver
replacment kit are shown for convenience and
verification of inclusion.
To change a worn driver:
1. Using a T-20 Torx, loosen the four screws
side of the unit. Refer to Figure N.
2. Remove the four screws. Refer to Figure N.
3. Remove housing end cap
Fig. N
4. Push up on the rear of the driver
click, then push the driver forward while holding it in
this position until it passes the upper bumper assembly.
Refer to Figure P.
5. Remove guide rods 20 . Refer to Figure O.
6. Remove upper bumper assembly
Fig. O
7. Lift the rear of driver until at an angle and pull the driver
out. Refer to Figure P.
8. Replace driver and follow steps in reverse to reassemble
9. Ensure new driver slides smoothly through the gun
before full reassembly.
14
17 on either
18 . Refer to Figure N.
18
17
19 until you hear a
21 . Refer to Figure O.
21
20
Fig. P
10. Return the driver, guide rods, bumpers and housing
end cap back onto the unit. It is important to try
the alignment of the driver and the flywheel before
screwing the housing end cap back on to the unit. This
can be done by connecting a battery and pushing then
releasing the nose of the unit against a bench or hard
surface. This will start the motor spinning.
nOTE: When the driver and the flywheel are correctly
aligned, you will hear the motor coast back down
from full speed. If the driver and the flywheel are not
correctly aligned, the motor may not start up, may
slow down much faster than normal along with a loud
grinding noise from the unit. If this happens remove
and reseat the driver, making sure the bumpers are
seated correctly.

WARNING: Always test the unit by firing 1-1/2"
(38 mm) staples in power setting 1 into scrap material,
to ensure that the tool is working properly. If tool does
not operate properly, contact a recognized D
service center immediately.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact D WALT Industrial Tool Co., 701
e
East Joppa Road, Towson, MD 21286, call 1–800–4-D
(1–800–433–9258) or visit our website www.D
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D WALT factory service center
e
or a D WALT authorized service center. Always use
e
identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
WARRAnTY sERViCE: Registering your product will
•
help you obtain more efficient warranty service in case
there is a problem with your product.
COnFiRMATiOn OF OWnERshiP: In case of
•
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
19
WALT
e
WALT
e
WALT.com.
e