Ryobi CFS1503 Manuel D'utilisation page 8

PAPER PUNCH
See Figure 8, page 11.
A paper punch template has been supplied with the sander
for aligning and punching holes in sandpaper. The punched
holes must align with the holes in the sander pad.
 Install sandpaper on the sander.
 Align the sander pad over the paper punch.
 Push down on the sander.
OPERATION
ROTATING THE SANDING SHEETS
See Figure 9, page 11.
The majority of wear in a precision sanding application occurs
at the tip of the sanding sheet. The unique Tri-Flex design of
the sanding sheets allows you to detach and rotate the top
two thirds of each, extending the life of the sheet.
To rotate the sheet, simply remove the top two thirds of
sanding sheet along the perforation. Rotate the sheet so
that a clean corner is located at the tip of the base. Press
the sheet firmly onto the sander pad.
NOTE: Scrubbing and polishing pads are not perforated and
cannot be rotated.
8 - English