Dispensing Hot Water; Maintenance And Daily Cleaning - Siemens TE809 Série Mode D'emploi

en

Dispensing hot water

¡ Risk of burns!
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The milk frother must be cleaned before
drawing hot water.
The appliance must be ready for use.
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
● Select the required setting for Hot water
by turning the rotary knob 6.
● Press the start button 8.
Please remove suction hose ▶ start
● Remove the milk suction hose 10c and
press the start button 8.
Hot water runs out of the milk frother
outlet 10.
Press the start button 8 again to cut the
process short.
Note: It is possible to set the temperature of
the hot water (see "Menu settings").
18
Maintenance and
daily cleaning
¡ Danger of electric shock!
Unplug the appliance before cleaning it.
Never submerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with a
soft, damp cloth.
● Do not use any cleaning agents that
contain alcohol or spirits.
● Do not use abrasive cloths or cleaning
agents.
● Always remove any limescale, coffee,
milk, cleaning or descaling fluid residue
immediately. Such residue can cause
corrosion.
● New sponge cloths may contain salts.
Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
● Pull the drip tray 23 with the coffee
grounds container 23c forwards and out.
Remove the panel 23a and grate 23b.
Empty and clean the drip tray and coffee
grounds container.