Sony VPL-FX51 Mode D'emploi page 20

Projecting
To turn off the power
1
Press the I / 1 key.
"Power OFF?" appears on the screen.
Note
The message will disappear if you press any key
except the I / 1 key, or if you do not press any
key for five seconds.
2
Press the I / 1 key again.
The ON/STANDBY indicator flashes in green and
the fan continues to run for about 120 seconds to
reduce the internal heat. Also, the ON/STANDBY
indicator flashes quickly for the first 40 seconds.
During this time, you will not be able to turn the
power back on with the I / 1 key.
3
Unplug the AC power cord from the wall outlet
after the fan stops running and the ON/STANDBY
indicator lights in red.
When you cannot confirm the on-screen
message
When you cannot confirm the on-screen message in a
certain condition, you can turn off the power by
holding the I / 1 key for about one second.
Direct power on/off function
When the projector is turned on or off by using a
system switch such as a breaker, set DIRECT PWR
ON to ON (page 27 (GB)). You can also disconnect
the power cord not pressing the I / 1 key.
About the air filter cleaning
When replacing the lamp, also clean the filter to
ensure optimal performance.
To enlarge the image (Digital Zoom
function)
You can enlage the point on the image you select.
This function works only when a signal from a
computer is input.
1
Press the D ZOOM + key on the Remote
Commander.
20
(GB)
The Digital Zoom icon appears in the center of the
image.
2
Move the icon to the point on the image you want
to enlarge. Use the arrow keys (M/m/</,) to
move the icon.
3
Press the D ZOOM + key again.
The image where the icon is located is enlarged.
The enlargement ratio is displayed on the screen
for a few seconds.
By pressing the + key repeatedly, the image size
increases. (ratio of enlargement: max. 4 times)
Use the arrow keys (M/m/</,) to scroll the
enlarged image.
To return the image back to its original size
Press the D ZOOM – key. Just pressing the RESET
key returns the image back to its original size
immediately.
To freeze the image projected (Freeze
function)
Press the FREEZE key. "FREEZE" appears when the
key is pressed. This function works only when a
signal from a computer is input.
To restore the original screen, press the FREEZE key
again.
To use the Laser Pointer function
Press the LASER key on the Remote Commander.
The laser pointer appears. The pointer is helpful in
indicating a particular point on the screen.
Digital Zoom icon