ResMed AirMini Mode D'emploi page 27

Hypoallergenic:
AirMini machine
Dimensions:
Weight:
Housing construction:
Air outlet:
AirMini air tubing
Material:
Length:
Inner diameter:
Electromagnetic compatibility
The AirMini complies with all applicable electromagnetic compatibility requirements
(EMC) according to IEC60601-1-2:2014, for residential, commercial and light industry
environments. Portable and mobile RF communications equipment should be used no
closer to any part of the machine, including cables, than the recommended 10 cm
separation distance. The AirMini has been designed to meet EMC standards. However,
should you suspect that the machine performance (eg, pressure or flow) is affected by
other equipment, move the machine away from the possible cause of interference.
The AirMini complies with Part 15 of the FCC Rules and Industry Canada license-exempt
RSS standards. Operation is subject to the following two conditions: This machine may
not cause harmful interference, and this machine must accept any interference received,
including interference that may cause undesired operation.
FCC ID: QOQBT121, IC: 5123A-BGTBT121
Additional information regarding the FCC Rules and IC compliance for this machine can
be found on www.resmed.com/downloads/devices.
Aircraft use
ResMed confirms that machine meets the Federal Aviation Administration (FAA)
requirements (RTCA/DO-160, section 21, category M) for all phases of air travel.
Material: Blended synthetic fibers in a
polypropylene carrier
Efficiency: >80% (average) when tested to
EN 13274-7
5.4" (W) x 3.3" (D) x 2.1"(H)
136 mm (W) x 84 mm (D) x 52 mm (H)
10.6 oz (300 g)
Flame retardant engineering thermoplastic
Proprietary connector, 16mm inner
diameter. Not compatible with EN ISO
5356-1 connectors.
Flexible plastic
6'2" (1.9 m)
0.6" (15 mm)
English 25