MC Crypt DJ-20 Notice D'emploi page 28

Connection and Control Elements
(1) MIC BAL. Control
This control is used to set the volume ratio between microphones 1 and 2.
(2) MIC LEVEL control
This control is used to set the volumes of microphones 1 and 2.
(3) Channel fader CHANNEL 1
Use the channel fader for adjusting the level of channel 1.
Slide control to the bottom position = minimum channel level
Slide control to the top position = maximum channel level
Channel faders for channels that are not in use should be turned down. This reduces the possibility of
interference.
(4) INPUT SELECTOR CHANNEL 1 switch
This switch specifies whether a line device or a record player is connected at channel 1.
LN position > a line device (CD player, cassette deck etc.) is connected to the CHANNEL 1 input so-
ckets.
PH position > a record player (with magnetic system) is connected to the CHANNEL 1 input sockets.
Always place the switch in the position intended for the device you have connected. �ailure to Always place the switch in the position intended for the device you have connected. �ailure to
do so results in distortion, which could damage the mixer and the connected devices.
(5) Channel fader CHANNEL 2
Use the channel fader for adjusting the level of channel 2.
Slide control to the bottom position = minimum channel level
Slide control to the top position = maximum channel level
Channel faders for channels that are not in use should be turned down. This reduces the possibility of
interference.
28