Gardigo 78520 Notice D'utilisation page 12

• The cables should be installed in such a way that they do not connect to hot or moving
parts of the engine e.g. fans or exhaust pipes. Secure the cables by using cable ties.
• Connect the red cable [ ] with the plus (+) of your car battery and the brown cable [ ]
with the minus (–) of the battery or the chassis of the car.
• The grey cable [ ] should be connected to terminal 15 (switched 12 V e. g. ignition,
car radio) of the car battery. The device will automatically switch on when the ignition
is off and will switch off when the ignition is on.
Important: If your car has a CAN/BUS connect the cable to the fuse of terminal 15.
• If the connection to terminal 15 doesn't work or is not available, then it is also possible
to install the device in an area of the engine compartment which is subject to high
vibrations. The vibrations of the engine will switch the device automatically off. When
the engine is not running the device will automatically switch on after 60 seconds.
• Install the high-voltage modules [ ] in areas where marten is most likely to pass
by. The modules have holes in the corners with which they can be assembled in the
engine compartment, either with tapping screws or cable ties.
When installing the high volt modules please make sure of the following points:
• Make sure that the cables are not installed near movable or hot parts of the engine.
• A direct contact with the chassis of the car can result in a short-circuit and the de-
struction of the device.
• Flashovers from the modules to parts of the car electronics cannot happen as the
voltage of 400 +/– 50 Volt can only create a spark of 0,7 mm length. A distance of 5
mm to all other electronic components will eliminate any potential danger of damage.
High Voltage! Please install the included yellow warning stickers by placing
them in locations that are seen immediately when opening the bonnet.
• Install the fuse and start the device by pressing the On/Off button. The red [ ]and
white [ ] LED will light up, if the device is installed correctly.
• The red LED [ ] will flash every 22 seconds and when the ultrasonic frequencies
activated. The white LED [ ] will flash 3 – 4 times if an intruder has triggered the
system by touching the high volt modules. This is an additional deterrent against the
marten.
Note: If the voltage of the car battery goes below 11 V, the Marder Schock Pro will au-
tomatically switch itself off. This will save the battery from total discharge. When the
„Car-Battery-Controll" (CPC) is activated, the device will offer no protection against an
intruder. As soon as the voltage of the car battery goes above 12 V, the device will auto-
matically be activated again.
12