FRIGOGLASS EasyPick Mode D'emploi page 10

ENG
a. After unpacking, check the cabinet for any damage caused during transportation. In the event of
damage, please contact the forwarding company.
b. Always ensure that your merchandiser is installed on a stable surface/floor.
c. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This gives the oil time to run back to the compressor after transit and installation.
d. Allow a minimum gap of 100mm from ventilation openings.
e. Use only included power cord for connecting the ICM plug to power outlet.
Note: Relocation of the ICM inside the outlet
a. Empty the ICM and unplug from mains supply.
b. Move the unit to the desired location with the assistance of another person.
10