Connecting A Matching Endoscope Camera; Switching The Device On/Off - VOLTCRAFT BS-1000T Mode D'emploi

If the SD card is not inserted correctly, the endoscope cannot make any recordings.
Do not drop the SD card and do not subject it to vibration or impacts.
Otherwise, stored images may be damaged.
Do not store or use the SD cards close to devices that generated
strong magnetic fields, such as TVs, speakers or magnets. Also avoid
sites with electrostatic charges. Otherwise, the images/videos stored
on the SD card may be lost.
Do not subject SD cards to any direct solar irradiation or other sourc-
es of heat. Otherwise, the SD card may deform and become useless.
Do not pour any liquid onto the SD card. Always keep the SD card in
the storage box included to protect the data stored. Do not bend the
memory card, do not use any force and do not subject it to impacts.
Do not keep the SD card in any hot, moist of dusty environments.
d) Connecting a matching endoscope camera
e) Switching the device on/off
Keep the button pressed for 3 seconds to switch the endoscope on or off.
After the start-up-screen, the battery charging state and the SD card capacity is briefly displayed on the screen.
Charge the endoscope when the battery level is low. A camera live image is displayed on the screen.
The endoscope is now in preview mode.
1. Connect a compatible camera to the socket. Observe correct
alignment; the hollow part on the plug (at the endoscope cam-
era) should fit over the protruding part on the socket (basic
device). Make sure not to break off the pins.
2. Turn the metal screw lock clockwise to fasten the camera.
3. Loosen the camera by turning the metal lock counter-
clockwise.
For a matching endoscope camera, see the chapter on
matching accessories.
27