Publicité
Les langues disponibles
Les langues disponibles
TO INSTALL THE DRIVE
P H
O N
E S
÷ Switch off the power of the personal computer and remove the cover or the front
panel.
÷ Remove the blank panel installed at the front of the 5.25 inch slot.
Installation is not possible when there is no empty slot.
÷ Install the fixation slide rails on the drive. (If slide rails are required, contact the
shop where you bought the computer or the computer manufacturer.)
÷ Insert the drive into the slot.
÷ If fixing is required, fix the drive according to the instruction manual for the computer.
Use mounting screws with a length of 5 mm (3/16 in.) or less.
Use of long screws may damage the drive.
Install the drive after the power supply of the personal computer has
been switched off.
When the mounting screws are loose etc., the vibrations from disc
rotation can generate a ripping noise, so that the screws should be
tightened securely.
The drive installation method differs according to the computer type.
For details, please refer to the manuals of your computer.
D V
D
B U
S Y
Fig. 3
9
<DRC1074>
En
Publicité
