Maintenance; Cleaning The Tool; Tool Inspection - Titan HKE-L Notice D'instructions

8.

Maintenance

8.1. Cleaning the tool

Soil and debris hamper the proper functioning of the tool. For this
reason the following areas should be cleaned once a week.
Blow off using compressed air if possible (wear protection goggles).
Lubricate with fine conventional spray oil afterwards.

8.2. Tool inspection

Perform a daily visual inspection of the outside of the unit. The early detection of
damaged parts extends the life of the unit. Replace all damaged parts immediately
with Original TITAN spare parts.
HKE-L
Insertion slot
Cavities between the upper and lower jaws
Tensioning wheel
Gripper plate
For health reasons please do not use any cleaning
agents which contain solvents.
H 223 EU 05/10
27 / 47