Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
Adjustments
7.1. Cutter adjustment
The cutter has been adjusted for the
respective thickness in the case of
varying strap thicknesses.
Release hexagon nut 72, turn set screw
49 (thread pin with flat point) by means
of a screwdriver,
clockwise
counter clockwise = greater cutting
Fasten hexagon nut 72 after adjustment has been completed.
Note! After adjustment there should not be any, or very
few, signs of cutting on the lower strap.
7.2. Distance between the feed wheel and the gripper plate
The distance between the feed wheel 29
and the gripper plate 503 is adjusted to
0.2 mm .The adjusting screw 84 is
located behind the plastic cover of the
housing. Unscrew the hexagon nut 8
using the 10 mm open-jawed spanner
and adjust a 0.2 mm gap at the
adjusting screw 84.
Note!
The feed wheel and the gripper plate may not come
into contact with each other. Otherwise both parts
will be subject to premature wear.
HKE-L
= less cutting
depth
depth
H 223 EU 21/06
49
72
84
8
25 / 47
Publicité
Chapitres
Table des Matières
