Adjusting Strap Width - Titan HKE-L Notice D'instructions

7.3. Adjusting strap width

The strap guide 500 located next to the
feed wheel is replaced when the strap
width is modified. In order to do so the
safety ring has to be removed by means
of a screwdriver and the lifting rocker
509 and the cutting lever 35 pressed
together. The strap guide may now be
pulled off towards the front and be
replaced with the strap guide for other
strap widths.
afterwards.
Since the strap is guided at three points
in the tool the rear strap guide 42 and
the strap guide front 76 also have to be
set in such a way that the punching is
placed at the centre of the strap.
In order to do this, loosen the two
fastening screws for the rear strap guide
42 and adjust the strap guide to the
respective strap width.
Left = 13mm
Middle = 16mm
Right = 19mm
Fasten screws afterwards.
Also loosen the cap screw at the front strap guide 76 and place the corresponding
number of washers DIN 125-6.4 under the strap guide:
13 mm band width = 2 washers
16 mm band width = 1 washer
19 mm band width = no washer
Fasten cap screw again after adjustment.
HKE-L
Replace safety ring
H 223 EU 21/06
76
500
500
42
26 / 47