Adjusting Strap Width - Titan HPE-L Notice D'instructions

7.1. Adjusting strap width

The strap guide (n) located next to the feed wheel is replaced when the strap width is
modified. In order to do so the safety ring has to be removed by means of a
screwdriver and the rocker (c) and the cutting lever (b) pressed together. The strap
guide may now be pulled off toward the front and be replaced with the strap guide for
other strap widths. Replace safety ring afterwards.
Strap width 13 mm, order no. 2240002-500
Strap width 16 mm, order no. 2240002-501
Strap width 19 mm, order no. 2240002-502
Since the strap is guided at three points in the tool the rear strap guide (l) and the strap
guide front (m) also have to be set in such a way that the punching is placed at the
centre of the strap.
In order to do this, loosen the two fastening screws for the rear strap guide (l) and
adjust the strap guide to the respective strap width.
Left =
Middle =
Right =
Fasten screws afterwards.
Loosen the countersunk head screw and the hex. nut at the strap guide front 302 and
place the appropriate number of washers DIN125-6.4 Pos. 78 under the strap guide:
13 mm band width = 2 washers
16 mm band width = 1 washer
19 mm band width = no washer
Re-tighten the countersunk head screw and the hex. nut after adjustment.
Note!
Do not mount the strap guide front too firm. Keep it slightly
turning in order to reduce wear.
m
HPE
13mm
16mm
19mm
H 224 EU 12/15
l
n
30 / 54