8.
Maintenance
8.1. Cleaning and maintenance of the unit
Insertion slot.
Hollow spaces of the sealing pincers.
Transport wheel.
Guide screw
Then oil it with a commercial spray oil.
Maintenance unit!
daily check of the compressed air
daily check of the oil level
draining the water separator
cleaning the filter according to instructions
Tool inspection!
Perform a daily visual inspection of the outside of the unit. The early detection
of damaged parts extends the life of the unit. Replace all damaged parts with
new parts.
MAX-L
Dirt and abrasion impair the function of the unit. Therefore clean
the following areas every week.
If possible, perform air-cleaning (wear protective glasses).
Do not use any solvent containing cleaning agents for
H 264 EU 25/12
reasons of health.
31 / 53