Loading The Appliance Door - Bosch B18 Série Instructions D'installation

Function of different parts:
1. Double threaded bolt on the adjusting rail: for vertical
adjustment of the furniture door.
2. Side brackets: for adjusting the depth of the furniture front.
3. Nuts on the double threaded bolt:
for securing the furniture front to prevent lateral
movement.
4. Lower brackets:
for securing the furniture front to prevent lateral
movement.
Important information for furniture doors with cutout
(appliances with ice and water dispenser, wine storage
cabinets):
The cut edges of the door cutout must be protected before
humidity penetrates. To do this, use the means suitable
for the material and the shape of the furniture door
(e. g. edge veneer, edge sealant).
Panel unification kit
In the case of 30" and 36" wide appliances 2 adjacent
furniture doors can be attached instead of one large door.
These furniture doors must be connected to a metal strip on
the rear.
This metal strip can be purchased from customer service as
an optional accessory, see the section on "Optional
accessories" on page 17.
When attaching the metal strip to the furniture doors,
observe the maximum possible length of the screws and the
position of the drill holes. Always screw into the best load-
bearing material of the furniture door.
NOTE
– Never screw into fillers, decorative strips or similar.
– If only one furniture door is to be attached to the
door of a 30" or 36" wide appliance, attach the
supplied sandwich plate to the adjusting rail and
lock into position.

20. Loading the appliance door

When attaching the furniture doors, it is recommended to
load the door storage compartments in the appliance with
weights in order to ensure that the gap width is as precise as
possible.
Recommendations:
18" Appliance:. . . . . . . . . . . . . . . . . . 22 lbs / 10 kg
24" Appliance:. . . . . . . . . . . . . . . . . . 33 lbs / 15 kg
30" Appliance:. . . . . . . . . . . . . . . . . . 44 lbs / 20 kg
31