Care And Cleaning - Zanussi ZYB590 Notice D'utilisation

TYPE OF DISH
Bread rolls

Care and cleaning

Warning! Refer to "Safety information" chapter.
Pyrolytic cleaning
Warning! The oven becomes very hot. There is the
risk of burns!
Important! Do not use Pyrolytic cleaning function and
hob at the same time (if it is installed with the appliance).
It can cause overheating and damage the appliance.
Before Pyrolytic cleaning:
• Remove all parts from the oven.
To remove shelf supports rails refer to section "Re-
moving the shelf support rails".
• Close the oven door correctly.
1. Remove the worst of the residual dirt manually.
2. Push
button again and again until the display
shows .
– " Pyro " message and
– An acoustic signal sounds. This is to remind you
to remove all parts from the oven.
– The temperature display shows „P1" or „P2"
– The clock display shows "2:00" or "2:30"
– Duration
flashes for approximately 5 seconds.
3. While Duration
necessary length for the procedure:
– 2:00 for a low degree of dirt,
– 2:30 for a high degree of dirt.
4. Push the Pyrolytic cleaning
cleaning.
When the oven starts to heat up, the rising bars on
the symbol indicate that the temperature inside the
oven increases.
When the oven reaches pre-set temperature, the door
locks and appears on the display.
At the end of the pyrolytic cleaning process, the display
shows the time of day. The oven door is locked. Once the
32
Pizza Function
Level
1
appear on the display.
flashes, use or to set the
button to start the
Cooking time in minutes
temp.°C
200
oven cools down, an acoustic signal sounds and the door
unlocks.
To stop the pyrolytic cleaning cycle at any time,
push
Wait until the door lock is off to use the oven.
Switch off time for Pyrolytic cleaning
You can set the switch off time for Pyrolytic cleaning
with the clock function End
1. Repeat above procedure from point 1 to point 3.
2. Push the time function button
The display shows
3. Push
Cleaning the oven door
The oven door has four panels of glass.
Remove the oven door and the internal panels of glass to
clean it.
Removing the oven door and the internal panels of glass
1
Open the door fully
and hold the two door
hinges .
15~25 on flat baking tray
button.
and the flashing arrow.
or to set required end of the cycle time.
2
Lift and turn the levers
on the two hinges
NOTES
.
.