Zanussi ZYB590 Notice D'utilisation page 33

3
Close the oven door to
approx. 45°. Then pull for-
ward and remove it from
its seat.
5
Release the locking
system to remove the in-
ternal panel of glass.
90°
7
Turn 2 fasteners by
90° and remove them from
their seats.
Clean the glass panels with water and soap. Dry them
carefully.
Inserting the door and the glass panels
When the cleaning procedure is completed, insert the
glass panels and the oven door. To do so, follow above
steps in opposite order.
4
Place the door on a
stable surface and a soft
cloth.
6
2
1
8
Carefully lift and re-
move the panels of glass
one after another. Start
from the uppermost.
The glass panels are
marked. Make sure you
put the glass panels back
in the correct order, as the
picture shows.
Oven lamp
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.
Replacing the oven light bulb/cleaning the glass
cover
Warning! Be careful! There is the risk of electrical
shock!
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
heat-resistant oven light bulb. New oven light bulb
must have the same parameters as your previous one.
4. Install the glass cover.
Make sure you insert the
internal panels of glass in-
to the right seats, as the
picture shows.
33