Adjusting The Sound Characteristics; Quickly Attenuating The Sound; Changing The Sound And Display Settings; Menu - Sony CDX-R3300 Mode D'emploi

Adjusting the sound
characteristics
You can adjust the balance, fader, low pass filter
and subwoofer volume.
1
Press (SEL) repeatedly until "BAL,"
"FAD," "LPF" or "SUB" appears.
Each time you press (SEL), the item changes
as follows:
1 t MID*
LOW*
BAL (left-right) t FAD (front-rear) t
LPF (low pass filter)*
SUB (subwoofer volume)*
*1 When EQ3 is activated (page 21).
*2 When "SUB" is selected (page 20).
*3 The cut off frequency is adjustable to 78 Hz,
125 Hz or OFF.
*4 The volume level is adjustable between –10 and
+10 steps. (Below –10, "ATT" is displayed.)
2
Press the volume +/– button to adjust
the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
Press (ATT).
After "ATT-ON" momentarily appears,
"ATT" appears in the display.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).
20
1 t HI* 1 t
2 3 t
*
2 4
*
Changing the sound and
display settings

— Menu

The following items can be set:
Set up
1
• REAR/SUB* — to switch the audio output
REAR or SUB.
– Select "REAR" to output to a power
amplifier.
– Select "SUB" to output to a subwoofer.
• CT (Clock Time) (page 18)
• A.SCRL (Auto Scroll)*
• DEMO* 1 — to turn the demonstration display
on or off.
– Select "ON" to activate the demonstration
display (The demonstration starts about 10
seconds after the unit is turned off).
– Select "OFF" to deactivate the
demonstration display.
• BEEP — to turn the beeps on or off.
• DIM — to change the brightness of the display.
– Select "ON" to dim the display.
– Select "OFF" to deactivate the Dimmer.
2 (page 12)