Cut-Sheet Feeder Controls; Inserting Paper From The Loading Tray; Setting The Top Of Form Position - Oki Data Microline 3320 Manuel De L'utilisateur

Cut-Sheet Feeder Controls

The printer's control buttons also control the operation of the Cut-Sheet
Feeder. You can also use programming commands to control the CSE (See
Appendix A.)

Inserting Paper from the Loading Tray

You can advance paper from the selected loading tray to the print start
position by simply pressing the FF/LOAD button on the printer.
Paper already in the print position will be ejected when you press the FF/
LOAD button or use the CSF insert command in a program.

Setting the Top of Form Position

Although the Top of Form (TOF) for the CSF is preset to 21.6 mm (0.85
inch) from the top of the sheet, you can adjust it. To ensure good print
quality, however, we suggest the top margin be at least one inch (25.4
mm). If your word processing package automatically inserts a top margin,
you should set the CSF top of form position to the top of the paper. In this
way, you can use your word processor's default margins, so you won't have
to change the word processor's default margins for every document file
you create.
Deselect the printer for this procedure (SEL light off).
To set Top of Form, first place the paper in the position you want using
one of the methods outlined below.
1. Standard Line Feed: Press the LF button once to feed the paper
forward one line at a time. If you hold the LF button down, the paper
will
move forward continuously in one-line increments until you
release the button.
2. Fine Line Feed: While holding down the SHIFT button, press FF/LOAD
to move the paper up, or LF to move the paper down.
2. OPERATION