Removal Of The Cut-Sheet Feeder - Oki Data Microline 3320 Manuel De L'utilisateur

12. Ensure that the paper lever on the printer is in the
")
(Set at "
Ensure that the printer's paper lever is
with the CSF. If you do not have the paper lever in the single sheet posi-
tion, the paper will not feed properly. The printer could print an entire
page without any paper, possibly damaging the printhead.

Removal of the Cut-Sheet Feeder

1. Turn off the printer main switch.
2. Remove the CSF gently by reversing the order of the installation.
NOTE: Be sure to disconnect the connector
been turned off.
1. INSTALLATION
"
set at " whenever you print
after the main
only switch
single sheet setting.
of the printer has