Preparing The Loading Tray - Oki Data Microline 3320 Manuel De L'utilisateur

CUT-SHEET FEEDER

Preparing the Loading Tray

1. Push the paper set lever backwards on the right side of the CSF to the
"RESET" position.
2. Press down the guide levers on either side at the back to RELEASE the
guides so that they can be adjusted to fit the paper stack. The move-
ment of the left guide is limited to ensure that paper will cover the
groove in the platen during printing.
For CSF 3391-S/3391-D
When setting sheets measuring 265 mm or less in width, remove one rear
sheet support.
When setting sheets measuring 210 mm or less in width, remove both rear
sheets supports.