Lenze STANDARD−I/O PT Mode D'emploi page 45

)
Note!
The basic device is only functioning if a HIGH level is applied to X3/28
(controller release via terminal).
Please observe that the controller can be inhibited through various
ƒ
sources. All sources act like a series connection of switches.
If the drive does not start in spite of the controller release via X3/28, check
ƒ
if the controller inhibit is set via another source. Another source could be
the s key of the keypad.
EDK82ZAFSC−100 DE/EN/FR 4.0
l
Commissioning
Commissioning steps
7
45