Keycode; Change Code; Delete Code - BEHAbelt PPuls HP01 Mode D'emploi

seconds. For 12h display you have to additionally select „AM" for mornings and „PM" for after-
noons with the arrow keys left
key [5] to leave this menu item and to return to the previous menu level.
2.2.5.2 Language: Select display language. You can choose German, English or Spanish.
To change the language, select desired language with arrow keys up
confirm selection by pressing key [6]
and to return to the previous menu level.

2.2.5.3 Keycode

It is possible to set a safety code which blocks all setting possibilities (with the exception of
selection and use of saved recipes). It is now impossible to change system parameters or
recipes, without knowing the preset keycode. The latter has to be canceled before changes are
made.
Press key [6] briefly to go to the following sub-menus:
2.2.5.3.1 Change code: New entry or change of existing keycode.
Codes can consist of 1 to 8 digits and range from 0 to 99999999.
Please memorize preset code well! If you forget the code, only BEHAbelt service can
unlock the system. Press key [6]
In case of new entry (so far no code used):
Enter desired code and confirm by briefly pressing key [6]
pressing key [5]
key [5] to leave this menu item and to return to the previous menu level.
Changing an existing code:
First enter existing code (old) and confirm by briefly pressing key [6]
be correct to be able to continue. Enter desired new code and confirm by briefly pressing
key [6] . You can also discontinue the entry by pressing the key [5]
no new code is generated and the system is still locked with the old code. Use key [5]
leave this menu item and to return to the previous menu level.
2.2.5.3.2 Delete code: Delete an existing keycode.
Press key [6] long (>1s) to delete code. Enter existing code and confirm by briefly pres-
sing key [6] . The entry has to be correct to be able to cancel the existing code. Use key
[5] to leave this menu item and to return to the previous menu level.
/ right
briefly to create or change the code.
long or delete the last entered digit by pressing key [5]
. Confirm by pressing key [6]
long (>1s). Use key [5]
briefly. Use
/ down
to leave this menu item
. You can cancel the entry by
briefly. Use
. This entry has to
long. In this case
and
to
39