Alarm (Time); Id (Identification Number); Final Temperature; Dwell Time Format - BEHAbelt PPuls HP01 Mode D'emploi

2.2.1.2 Alarm (time): Setting of alarm time in h/m/s.
Press key [6] long (>1s) to change settings. First enter two digit value for hours and con-
firm by pressing key [6]
entering minutes and seconds proceed accordingly. Use key [5]
and to return to the previous menu level.
2.2.2 ID: 3-digit identification number. Choose and set an identification number between 0
and 200, which merely serves organizational purposes.
Please note:
The ID may e.g. be used for identifying the unit (controller), the operator, the welding process,
the machine to which the welded belt is connected or the press which is used. It is also saved
for documentation purposes together with the log data of the welding process (PPuls Xpert
versions only). The number has no impact on the other functions of the controller.
Press key [6] long (>1s) to change settings. Enter desired value and confirm by briefly
pressing key [6]
menu level.
2.2.3 Final temperature: Setting the final temperature for cooling. The cooling pump stops
when both heating platens have reached or have fallen below this temperature. It is possible to
set temperatures from 0°C to 300°C.
Press key [6]
pressing key [6]
menu level.
2.2.4 Display: Setting of display information.
Press key [6] briefly to go to the following sub-menus:
2.2.4.1 Dwell time format (h/m/s / Sec.): Display of dwell time in hours/minutes/seconds
or in seconds.
Press key [6] long (>1s) to change settings. Select desired setting with arrow keys left
/ right and confirm by pressing key [6]
menu item and to return to the previous menu level.
. briefly. Cursor will automatically move into the next field. For
. Use key [5]
long (>1s) to change settings. Enter desired value and confirm by briefly
. Use key [5]
to leave this menu item and to return to the previous
to leave this menu item and to return to the previous
briefly. Use key [5]
to leave this menu item
to leave this
37