Connectors; Switching On/ Off And Product Information; Key Functions - BEHAbelt PPuls HP01 Mode D'emploi

2.1.2 Connectors

PPuls Element bottom
1
[1] Connector for cooling pump
[2] Connector for upper heating platen
[3] Connector for lower heating platen
[4] Mains cable
[5] Mains On/Off switch
2.1.2

Switching on/ off and product information

Connect the unit to mains. The unit switches on automatically (PPuls Extended), for PPuls
Element switch the unit on using the On/Off switch [7]. Directly after switching on, it shows it
hard (HW)- and software (SW) version and internal information (OPT). Note that information
on your user manual, it can be required for service.
After a few seconds, the unit shows the starting screen. Content of starting screen depends on
the settings.
To switch off the unit, unplug it (PPuls Extended), for PPuls Element switch the unit off using
the On/Off switch [7].

2.1.4 Key functions

[1] Temperature and time setting (see 3, page 17):
-
-
[2] Recipe storage:
[3] System settings:
34
2 3
Short press to enter the time and temperature setting menu
Long press to change parameters
Enter recipe storage (see 4, p.18)
Enter menu (see 2.2, p.12)
PPuls Element top
5 4