WAGNER W 890 FLEXIO Traduction Du Mode D'emploi Original page 46

GB
Malfunction
Poor covering
capacity on the
wall
27. Technical Data
Max. viscosity:
Interior wall paint
Varnish paints, glazes, etc.
Max. flow rate:
Interior wall paint
Varnish paints, glazes, etc.
Power source
Power consumption
Atomizing output:
Double insulation
Sound pressure level*
Sound pressure output*
Oscillation level**
Air hose length
Weight
* Measured in accordance with EN 60745-1
Information about the oscillation level
The specified oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational
strain.
Attention! The vibration emission value can differ from the specified value when the
electric tool is actually in use, depending on how the electric tool is being used. It is
necessary to specify safety measures to protect the operating personnel. These measures
are based on an estimated shutdown during the actual conditions of use (all parts of the
operating cycle are taken into consideration here, for example periods when the electric
tool is switched off, and, when it is switched on but running without any load).
38
Cause
•
Spray material is too cold
•
Highly absorbent surface or paint
with poor covering capacity
•
Distance too large
Technical Data
4000 mPas
170 DIN-s
400 ml/min
200 ml/min
230 V , 50 Hz
~
630 W
200 W
72 dB (A); Uncertainty K = 4 dB
85 dB (A); Uncertainty K = 4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
3.5 m
approx. 6.6 kg
W 890 Flexio
Remedy
➞ The material you are
spraying should be at
room temperature
➞ Cross spray (Fig. 13)
➞ Closer to the object