Denon RCD-M33 Mode D'emploi page 16

ENGLISH
Setting the Timer
The power can be set to turn on and off at a specific time or at the same time everyday.
NOTE:
• Please do not change the setup function of this unit after performing the timer setup. In the
event the setup function is changed, the timer start mode may not start properly.
1, 19 3, 5, 7, 9, 11, 13, 15, 17
2, 4, 6, 8, 10, 12, 14, 16, 18
Example: Setting the tuner to turn on at 1:35 p.m., off at 1:56 (with FM 92.50 MHz preset at
channel 3) with everyday timer.
Press the power operation
1
switch to turn on the power.
Press the MENU/ SET button to
2
set the timer setting mode.
9
Press either the or
8 button as desired.
3
Main unit
• The everyday timer is selected and "EVERYDAY"
appears in the display.
4 Press the MENU/ SET button.
9 8
Use the or
5 button to set the
"TUNER" mode.
Main unit
16
1
19
2, 4, 6,
8, 10, 12,
14, 16, 18
3, 5, 7,
9, 11, 13,
15, 17
Say that FM 87.5 MHz is tuned
Main unit Remote control unit in preset channel number " 1 ".
Flashes
Main unit
Remote control unit
Flashes
Remote control unit
Main unit Remote control unit
Flashes
Remote control unit
6 Press the MENU/ SET button.
Main unit
Use the 9 / 8 button to set the preset channel
number.
7
Main unit
8 Press the MENU/ SET button.
Main unit
Use the 9 or 8
9 button to set the hours
for the timer on time.
Main unit
10 Press the MENU/ SET button.
Main unit
9 8
Use the or
button to set the
11
minutes for the timer on
time.
Main unit
12 Press the MENU/ SET button.
Main unit
9 8
Use the or
13
button to set the hours
for the timer off time.
Main unit
Press the MENU/ SET button.
14
Main unit
Remote control unit
Flashes
Remote control unit
Flashes
(If the timer has already been
Remote control unit
set, that number flashes.)
Flashes
Remote control unit
Flashes
(If the timer has already been
Remote control unit
set, that number flashes.)
Flashes
Remote control unit
Flashes
(If the timer has already been
Remote control unit
set, that number flashes.)
Flashes
Remote control unit
Flashes
(If the timer has already been
Remote control unit
set, that number flashes.)