Frame Depth; Frame Width; Seat Pan; Cushion Installation - Quickie SR45 Mode D'emploi

E N G L I S H
K. FRAME DEPTH
19
1. Back adjustment
a. Loosen and remove the bolts (C & E) located in front of back mounting plate on both
sides of the chair.
b. Slide the backrest along the seat rail to the desired position.
c. Replace and tighten the bolts (C & E) at desired position on both sides of chair.
IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.
NOTE– Use a torque setting of 120 in.-lbs. When setting-up back depth adjustment.
2. Hanger Receiver Adjustment
a. Loosen and remove the socket head screw (F) from the seat rail.
b. Slide the hanger receiver (G) in the seat rail to the desired position.
c. Replace and tighten the socket head screws.
d. Repeat on the other side.
IMPORTANT NOTE– These adjustments may also require re-positioning the carriage over the base frame.
IMPORTANT NOTE– The adjustment on each side should be exactly equal.
NOTE– Use a torque setting of 120 in.-lbs. When setting-up hanger receiver.
L. FRAME WIDTH
The frame of the SR45 is built to accommodate growth by using the growth kit components.
Width Adjustment
a. Remove the bolts (H) from both ends of the strut tubes (I) for all strut tubes.
b. Replace with the appropriate length strut tubes
c. Tighten the bolts (H) at each end.
d. Repeat for each strut tube.
NOTE– Use a torque setting of 200 in.-lbs. when setting up rocker frame width.
Use a torque setting of 120 in.-lbs. when setting up base frame.
23
M. SEAT PAN
The seat pan of the SR45 is designed to accommodate depth adjustment. There are two dif-
ferent lengths of seat pans to accommodate different seat depth ranges.
Loosen all four seat pan screws (A) and slide seat pan forward or rearward so as to keep
the front of the seat pan approximately 1/2" behind the vertical tube of the hanger receiver.
Re-tighten all four screws, ensuring the clamps are completely engaged onto the seat tubes.
NOTE: If this causes front seat pan clamps to hang off the end of the seat tube, or if the seat pan clamp
would interfere with the rocker, remove the screws completely from the front seat pan clamps and
re-align with appropriate holes in the seat pan.
N. CUSHION INSTALLATION
a. Place cushion on seat pan with hook material side down. The beveled edge of the
cushion should be in front.
b. Press firmly into place.
20
21 22
17
IX. SET-UP & DJUSTMENT
19
E
C
20
F
G
21
I
H
22
H
I
H
23
A
118611 Rev. B