Samson CONCEPT 99 Mode D'emploi page 8

CB99 Belt Pack Transmitter - Callouts
1. Input Connector - Connect the input device via the
mini-XLR connector. The CB99 is supplied with
either a lavalier, headset microphone or ¼" instru-
ment cable.
2. Status Indicator - This LED displays the operation mode:
GREEN
RED
Flashing GREEN
3. Power/Mute Switch - Press and hold to turn the unit
on or off. Press and release to mute or unmute the
transmitter.
4. Belt Clip - Use this clip to fasten the CB99 trans-
mitter to a belt or guitar strap.
5. Battery Cover Release - Push in both sides and pull
back to open the CB99 battery cover.
6. Antenna - This permanently attached transmitter
antenna should be fully extended during normal
operation.
7. Input GAIN Control - This control adjusts the trans-
mitter input sensitivity to work with microphone
and instruments inputs. For optimal performance,
using the included screwdriver, set the input GAIN
control to where you see the CR99 Audio Meter
maximum indicator start to light under high levels,
then turn down slowly until the maximum indicator
stops lighting.
8. Battery Holder - Insert two standard AA (LR6) bat-
teries here, being sure to observe the plus and
minus polarity markings shown. Although recharge-
able NiCad and NiMH batteries can be used, they
do not supply adequate current for more than four
hours. WARNING: Do not insert the batteries back-
wards; doing so can cause severe damage to the
CB99 and will void your warranty.
9. IR Lens - This window is used to capture the infra-
red signal sent from the CR99 receiver
the IR SET to channelize the transmitter.
10. Plastic Screwdriver - Designed for use in adjusting
the CB99 input GAIN (#7) control.
8
Normal Operation
Mute
Low Battery
d u r i n g