Warranty Claims - Exclusion Of Liability; Certificates - Guidelines; Shipping; Receipt - Helios MiniVent M1 150 N C Notice De Montage Et D'utilisation

Mini ventilateur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation and Operation Instructions
CHAPTER 2
GENERAL OPERA-
TING INSTRUCTIONS
MiniVent M1/150 N / C
2.0
Warranty claims – exclusion of liability
All versions of this documentation must be observed, otherwise the warranty shall cease to apply. The same applies
to liability claims against Helios. The use of accessory parts, which are not recommended or offered by Helios, is not
permitted. Any possible damages are not covered by the warranty. Changes and modifications to the unit are not
permitted and lead to a loss of conformity, and any warranty and liability shall be excluded in this case.
2.1

Certificates - guidelines

If the product is installed correctly and used to its intended purpose, it conforms to all applicable CE guidelines at its
date of manufacture.
2.2

Shipping

The fan is packed ex works in such a way that it is protected against normal transport strain. Carry out the shipping
carefully. It is recommended to leave the fan in the original packaging.
2.3

Receipt

The shipment (M1/150 N / C with codable overrun timer/interval operation, Ref.No. 6042) must be checked for dama-
ge and correctness immediately upon delivery. If there is any damage, promptly report the damage with the assistance
of the transport company. If complaints are not made within the agreed period, any claims could be lost.
2.4

Storage

When storing for a prolonged time, the following steps are to be taken to avoid damaging influences: Motor protection
by dry, airtight and dust-proof packaging (plastic bag with desiccant and humidity indicators). Vibration-free, water-tight
and constant-temperature storage at a temperature in the range -20 °C to +40 °C.
In case of a storage period of more than three months or motor standstill, maintenance must be carried out before
start-up according to chapter 4. In case of reshipment (above all, over longer distances; e.g. by sea), it must be che-
cked whether the packaging is suitable for the form and route of transport. Damages due to improper transportation,
storage or putting into operation are not liable for warranty.
2.5

Performance data

The unit type plate gives an indication of the mandatory electrical values; which must be coordinated with the local
supply network. The fan performances* were established on a test stand according to DIN EN ISO 5801.
2.6

Noise data

Noise data that refers to certain distances apply to free field conditions. With regard to installation, the sound pressure
level can differ significantly from the catalogue data, as it is highly dependent on the installation conditions, i.e. on the
absorption capability of the room and the room size among other factors.
3
EN

Publicité

Table des Matières
loading

Table des Matières