JVC KW-AVX820 Mode D'emploi page 63

Symptom
• Tracks are not played back as you have
intended them to play.
• Elapsed playing time is not correct.
• "Not Support" appears on the screen and
track skips.
• Noise is generated.
• Tracks cannot play back as you have
intended them to play.
• "Now Reading..." keeps flashing on the
screen.
• Correct characters are not displayed (e.g.
album name).
• While playing a track, sound is
sometimes interrupted.
• Bluetooth device does not detect the
unit.
• The unit does not make pairing with the
Bluetooth device.
• Echo or noise occurs.
• Phone sound quality is poor.
• The sound is interrupted or skipped
while using a Bluetooth audio player.
• The connected audio player cannot be
controlled.
• The unit does not response when you
tried to copy the phone book to the unit.
Remedy/Cause
Playback order may differ from the one played back using
other players.
This sometimes occurs during playback. This is caused by
how the tracks are recorded.
The track is unplayable.
The track played back is not a playable file format. Skip to
another file.
Playback order may differ from the one played back using
other players.
• Readout time varies depending on the USB device.
• Do not use too many hierarchy and folders.
• Turn off the power and on again.
For available characters,
The tracks are not properly copied into the USB device. Copy
tracks again, and try again.
• Search from the Bluetooth device again.
• Reset the unit. When "Open..." appears on the monitor,
search from the Bluetooth device again.
Enter the same PIN code for both the unit and target
device. If the PIN code of the device is not indicated on its
instructions, try "0000" or "1234."
Adjust the microphone unit position.
• Reduce the distance between the unit and the Bluetooth
cellular phone.
• Move the car to place where you can get a better signal
reception.
• Reduce the distance between the unit and the Bluetooth
audio player.
• Disconnect the device connected for Bluetooth phone.
• Turn off, then turn on the unit.
• (When the sound is not yet restored) connect the player
again.
Check whether the connected audio player supports AVRCP
(Audio Video Remote Control Profile).
You may have tried to copy the same entries (as stored) to
the unit.
57.
Continued on the next page
REFERENCES 63