Philips GC4444 Mode D'emploi page 17

Problem
Water drips from
the soleplate after
the iron has
cooled down or
has been stored.
Flakes and
impurities come
out of the
soleplate during
ironing.
The red light
flashes (GC4444,
GC4440, GC4430,
GC4425, GC4422,
GC4420, GC4412
only).
Possible cause
The set
temperature is
too low for
steam ironing.
You have used
the steam boost
function at a
temperature
setting below
3.
You have put the
iron in horizontal
position with
water still left in
the water tank.
Hard water
forms flakes
inside the
soleplate.
The automatic
shut-off function
has switched off
the iron (see
chapter 'Features',
section
'Automatic shut-
off function').
EnGlISh
Solution
Set a temperature of or 2
higher.
Set the temperature dial to a
setting between 3 and
MAX.
Empty the water tank.
Use the Calc-Clean function
one or more times (see
chapter 'Cleaning and
maintenance', section 'Using
the Calc-Clean function').
Move the iron slightly to
deactivate the automatic shut-
off function. The red AUTO/
OFF light goes out.
17