Philips GC4444 Mode D'emploi page 16

EnGlISh
16
Problem
The iron does not
produce a steam
boost.
Water droplets
drip onto the
fabric during
ironing.
Possible cause
The steam
control is set to
position 0.
The iron is not
hot enough and/
or the drip-stop
function has
been activated.
You have used
the steam boost
function too
often within a
very short
period.
The iron is not
hot enough.
You have not
closed the cap of
the filling opening
properly.
You have put an
additive in the
water tank.
Solution
Set the steam control to a
position between 1 and 6 (see
chapter 'Using the appliance',
section 'Steam ironing').
Set an ironing temperature
that is suitable for steam
ironing (2 to MAX). Put the
iron on its heel and wait until
the temperature light has
gone out before you start
ironing.
Continue ironing in horizontal
position and wait a while
before you use the steam
boost function again.
Set an ironing temperature at
which the steam boost
function can be used (3 to
MAX). Put the iron on its heel
and wait until the temperature
light has gone out before you
use the steam boost function.
Press the cap until you hear a
click.
Rinse the water tank and do
not put any additive in the
water tank.