Other Display Messages - Teuco 620 Mode D'emploi

EN
It is advised to set the timer from a minimum of 15 min to a maximum of 30 minutes depending on the type
of use. Setting the timer for greater than 30 minutes is possible based on the type of display that comes with
the pool, but the system will stop the whirlpool operation after 30 minutes.
The Menu/ok key serves to confirm the above operations; if it is pressed by mistake, it is possible
to return to the previous menu by pressing the "" key.
By pressing the Menu/ok key, the function "MONITORING", only for technical service, is selected. Exit by
pressing the "Menu/OK" and "Shift" keys at the same time".
To access this section, a 4-digit password is asked.
After the fifth incorrect password entry, the system will shut down functions for about 30 minutes and the
display will show a countdown.

OTHER DISPLAY MESSAGES

H O ON
2
appears when the system is filling up with water, in
which case the inlet solenoid valve at the overflow
tank must be open.
FILTER ON
appears when the filter pump is running and one of
the filtration programmes is in progress.

If the symbol on the display is turning, this means

the system is operating.

If the on the display is stopped, the system is in

stop .
40
00:00 01/12/2012
WEEK-END
H O ON
2
TIMER=01 .00 H:M
1
00:00 01/12/2012
WEEK-END
FILTER ON
TIMER=01 .00 H:M
1
00:00 01/12/2012
WEEK-END
TIMER=01 .00 H:M

1

620