JVC RX-6030VBK Manual D'instructions page 39

To change the transmission signals for
operating a VCR
1 Press and hold STANDBY/ON
2 Press VCR.
3 Enter manufacturer's codes using buttons
1 – 9, and 0.
4 Release STANDBY/ON
Now, you can perform the following operations on the
VCR.
STANDBY/ON VCR
VCR CH +/–
After pressing VCR, you can perform the following
operations on the VCR:
3
Start playback.
FF Fastwind a tape.
REW Rewind a tape.
7
Stop playback or recording.
8 Pause playback. To release, press 3.
REC PAUSE Press this button to enter recording
pause.
Then press 3 to start recording.
Note:
Refer also to the manual supplied with your VCR.
5 Try to operate your VCR by pressing
STANDBY/ON VCR.
When your VCR turns on or off, you have entered the
correct codes.
If more than one code is listed for your brand of VCR,
try each one until the correct one is entered.
Manufacturers' codes for VCR
Manufacturer
JVC
Emerson
Gold Star
Hitachi
Mitsubishi
NEC
Panasonic
Philips
RCA
Samsung
Sanyo
Sony
Zenith
* "01" is the initial setting.
VCR.
VCR.
Turn on or off the VCR.
Change the channels.
Codes
01*, 02, 03
10, 22
11
04
12
21
07, 13
09
05, 06
20
17, 18, 19
14, 15, 16
08
To change the transmission signals for
operating a DVD player
1 Press and hold STANDBY/ON
2 Press DVD.
3 Enter manufacturer's codes using buttons
1 – 9, and 0.
4 Release STANDBY/ON
Now, you can use the following buttons on the DVD player.
3
Start playback.
7
Stop playback.
¢
Skip to the beginning of the next chapters.
4
Return to the beginning of the current (or previous)
chapters.
8 Pause playback. To release, press 3.
DVD menu operations
After pressing DVD (or DVD MULTI*), you can use the
following buttons for DVD menu operations:
* RX-6030VBK and RX-6032VSL only.
TEST
1
4
MENU
7/P
ENTER
10
RETURN
MENU Display or hide the menu screen.
5 5 5 5 5 /∞ ∞ ∞ ∞ ∞ /3 3 3 3 3 /2 2 2 2 2
Select an item on the menu screen.
ENTER (10) Enter a selected item.
5 Try to operate your DVD player by pressing
STANDBY/ON DVD.
When your DVD player turns on or off, you have entered
the correct codes.
Manufacturers' codes for DVD player
Manufacturer
JVC
Panasonic
Philips
Pioneer
Sony
Toshiba
Yamaha
* "01" is the initial setting.
Manufacturers' codes are subject to change
without notice. If they are changed, this remote
control cannot operate the equipment.
DVD.
DVD.
FRONT L FRONT R
2 3
CENTER SUBWFR
5 6
SURR L SURR R
8 9
LEVEL
10
0
TA/NEWS/INFO 100
Codes
01*
02
04
03
05
06
07
37