Adjusting The Volume; Listening With Headphones Only; Turning Off The Sound Temporarily-Muting; Changing The Display Brightness-Dimmer - JVC RX-6030VBK Manual D'instructions

Adjusting the Volume

On the front panel
To increase the volume, turn MASTER VOLUME control
clockwise.
To decrease the volume, turn MASTER VOLUME control
counterclockwise.
From the remote control
To increase the volume, press VOLUME +.
To decrease the volume, press VOLUME −.
The volume level can be adjusted within a range of "0"
(minimum) to "50" (maximum).
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at a high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.

Listening with Headphones Only

You must turn off the speakers when you listen with
headphones.
1
Press SPEAKERS ON/OFF on the front
panel.
"HEADPHONE" appears on the display for a while.
The SPK indicator goes off and the H.PHONE indicator
lights up.
This cancels the Surround/DSP modes currently selected
and activates the HEADPHONE mode (see below).
2
Connect a pair of headphones to the
PHONES jack on the front panel .
HEADPHONE mode
When using the headphones, the following signals are sent
to the headphones regardless of your speaker setting:
–For 2 channel sources, the front left and right channel
signals are sent directly to the headphones.
–For multi-channel sources, the front left/right, center, and
surround left/right channel signals are down-mixed and
then sent to the headphones.
You can enjoy multi-channel sound sources using the
headphones.
Note:
While in the HEADPHONE mode, you cannot use any Surround /DSP
modes (see page 24).
After using the headphones
1 Press SPEAKERS ON/OFF on the front panel to
activate the speakers.
The H.PHONE indicator goes off and the SPK indicator
lights up.
2 Disconnect the headphones.
CAUTION:
Be sure to turn down the volume
• Before connecting or putting on headphones, as high volume can
damage both the headphones and your hearing.
• Before turning on speakers again, as high volume may be output
from the speakers.
Turning Off the Sound
Temporarily—Muting
You can turn off the volume temporarily.
Press MUTING on the remote control to mute the sound
through all speakers or headphones.
Remote
• "MUTING" appears on the display and the volume turns off
NOT
(the VOLUME indicator goes off).
To restore the sound, press MUTING again.
The VOLUME indicator lights up on the display.
• Turning MASTER VOLUME control on the front panel or
pressing VOLUME +/− on the remote control also restores
the sound.
Changing the Display Brightness—
DIMMER
You can dim the display.
Press DIMMER.
• Each time you press the button, the display dims and
brightens alternately.
13