Publicité
Les langues disponibles
Les langues disponibles
Touch start, speed selection 33/45, stop
With the touch switch 6 you can switch the device on and off and select the speed
of the motor:
Touch the touch field 1x briefly to start the motor at speed 33.
Each further touch changes between 33 and 45.
Place your finger on the switch 6 for at least 1.5 seconds to turn the device off.
Please note, that the touch switch needs five seconds to calibrate itself after
reconnecting the power supply.
You can recognize the currently set speed by the colour of the LED.
White = 33.3 rpm
Blue = 45 rpm
Mounting or exchanging a cartridge system
Change of cartridge system
Remove the coloured signal leads carefully from the cartridge pins with a pair of
tweezers.
Unscrew the cartridge.
Screw the new cartridge onto the head shell but do not tighten. Attach the leads to
the pins while observing the correct coding.
Instead of the factory-supplied pick-up cartridge any other cartridge with standard
half-inch mounting holes and a weight between 3 and 10 grams can be installed.
Change Headshell
Remove the coloured signal leads carefully from the cartridge pins with a pair of
tweezers.
Loosen the collar-lock 4 behind the head shell. Carefully pull the coloured signal
leads out of the head shell. Install the head shell in reverse order. Pay attention to
the correct colour coding:
R = Red, right channel
RG = Green, right channel ground
L = White, left channel
LG = Blue, left channel ground
Adjusting after change of pick-up cartridge system
For the precise adjustment of the so-called stylus overhang push the supplied
mounting gauge into the head shell with cartridge. The adjustment is correct if the
stylus is flush with the V-shaped recess in the gauge as viewed from above. When
viewed from the side the stylus should be seen within the rectangular recess of the
Fig.
1
Fig.
gauge. Adjust the cartridge in the head shell until the correct positions are
achieved. Lastly, tighten the mounting screws, put the head shell with cartridge
back on the tone arm and tighten the collar-lock 4.
à
ATTENTION!
During these mounting and adjustment procedures you must be
very careful not to damage the delicate stylus, cables and cantilever by
any brisk movements.
Fig.
4
Fig.
Fig.
7
2
Fig.
3
|
Le
A = rechter Kanal / right channel / canal droit
RG
=
rechter Kanal Masse / right channel ground /
masse
L
=
linker
LG
=
linker Kanal
masse
5
Fig.
6
L
canal
droit
Kanal / left channel / canal gauche
Masse left channel
ground /
canal
gauche
Publicité
