Wolf ICBCT15I/S Guide D'utilisation Et D'entretien page 19

W O L F
C O O K TO P
C E R A M I C G L A S S T O P C A R E
M A I N T E N A N C E
The induction cooktop is a sealed system that
contains a cooling fan and does not require
internal maintenance. The cleaning and care
information outlines the necessary mainte-
nance for the ceramic glass surface. A Wolf
authorized service center technician must
perform all other maintenance.
20
I N D U C T I O N C O O K TO P
C A R E
Follow these guidelines to avoid injury
and prevent permanent damage to the
cooktop.
Do not use cooktop as a cutting board.
Do not slide rough-bottom cookware across
the glass surface. Remove any resulting
marks immediately using the method
mentioned in Cooktop Cleaning.
Do not allow any item that could melt to
come in contact with the hot ceramic glass
surface. If such a condition occurs, remove
it immediately from the hot element with a
razor blade.
Do not place food directly on cooktop
surface when it is warm or hot.
Do not operate the unit if the ceramic glass
surface is broken. Contact a Wolf authorized
service center.
Do not place a trivet, wok support ring or
other metal stand directly onto the cooktop
surface.
Do not apply chlorine bleach, ammonia or
other strong chemicals or cleaners to the
cooktop surface.
Do not use abrasive cleaners or applicators.
Do not wipe the cooktop surface with a
sponge or dish cloth that may leave a film
of detergent; it will cause the cooktop to
discolor during the next heating cycle.
U S E & C A R E
C O O K TO P
C E R A M I C G L A S S T O P
Lock the cooktop before cleaning by touching
and holding the
Clean the top surface thoroughly before
operating the cooktop for the first time. Apply
approximately 5 ml of nonabrasive cleaner
(such as Elco Cook Top Cleaning Creme) to the
surface of the ceramic glass with a lightly
dampened clean cloth. Use a second clean
cloth to remove any remaining cleaner residue.
Wipe the cooktop surface with a dry cloth to
completely eliminate any remaining moisture.
The cooktop should be cleaned after each use.
Be careful not to wipe or clean any hot areas
to avoid personal injury. It will be safe to clean
each element area whenever the correspond-
ing residual heat indicator light has gone out.
C O O K T O P F R A M E
For general cleaning after each use, apply a
nonabrasive cleaner to the stainless steel
cooktop frame and gently wipe with a clean
towel or cloth. Be sure to remove any cleaner
residue from the frame and ceramic glass
surface before using the cooktop.
C L E A N I N G
symbol for 3 seconds.