Assignment Of The Digital Audio Input - Loewe Audio AC3 Mode D'emploi

Standard settings
OK continue to set the
Distance from the left front speaker.
➠ Measure the distances respectively from your listening
position to the front, surround and center speakers.
The Dolby Digital Decoder calculates the delay times
for the speaker signals from these so that they reach
the listener simultaneously.
Sound components wizard
Please enter the distance of the left front
speaker from your listening position here.
Sound components
Distance to left front speaker
4,2 m
Proceed
OK
3 4 S et the distance of the front left speaker from your
listening position in 0 cm steps.
OK continue respectively to the other speaker and
3 4 s et the distance.
➠ After setting the distance for the center speaker ...
OK continue to Adjust speaker level.
Sound components wizard
You hear a sound from every speaker one after
another. But you can also select the speakers
manually with the menu control buttons up/down.
Set the volume for the respectively active speaker
shown in blue so that you get approximately the
same volume impression from all the speakers.
Sound components
Adjust speaker level
0 dB
Proceed
OK
3 4 S et the volume for every speaker.
6  Select speaker manually.
➠ For balanced audio reproduction all speakers should be
set at the same volume level. A noise signal will be
reproduced automatically on each speaker in successi-
on. Set every speaker to equal perceived volume from
your sitting position.
4,2m 2,7m 4,0m
1,0m 0,9m
END
0dB 0dB
0dB 0dB
END
Preceding/next loudspeaker
OK continue to Subwoofer phase.
Sound components wizard
Here you can reverse the phase of your subwoofer. Test both values in music
reproduction and then select the one with which you get a better bass
reproduction.
Sound components
Subwoofer phase
0°
Proceed
OK
Switch to a station with music with P+/P– or start playback
with music on a DVD player.
3 4 T est both values (0º and 180º) and select the one
with which you get a clearer bass reproduction
from your sitting position.
OK to confirm the setting and exit the wizard.
This ends the sound component wizard for connection
and set-up of a speaker system.

Assignment of the digital audio input

For digital sound reproduction via the speaker system or the active spea-
kers from an external device, e.g. from a DVD player, you have to feed
the digital audio signal to the TV set at the AUDIO DIGITAL IN socket.
If the video signal is fed into the TV set via one of the Euro AV sockets
or COMPONENT IN, you have to assign the digital sound to the used
socket.
➠ You will find other details on this in the TV User Guide in the chapter
"Assignment of the digital audio input".
180°
END
7 -