EYENIMAL Outdoor Bark Control Guide D'utilisation page 10

Cap of the spray
refill housing

Screw by hand the cap of the spray refill housing then close the bedplate by turning it to the left
How to turn on/off the base:

Press the On/Off button

1 beep tone confirms it is on

The base light indicator lights on continuously for 3 seconds then flashes every 8 second: the base is on
How to insert and remove the battery of the transmitter collar:
The transmitter collar is designed to work with a 3V, CR2032 Lithium battery (included).

Loosen by hand the collar by following the arrow's way, then insert the battery in its housing by paying attention
to the polarity.

Close the collar
Deactivate the transmitter collar:
To deactivate the transmitter collar you have to remove the battery from its housing.
To increase the battery life of the transmitter collar, we recommend you to deactivate the unit if you are not
using it for a long period.
Functioning:
When the pet wearing the collar enters in the detection zone, the base emits up to 3 beep tones and/or 3 sprays each
5 second.
After 3 warnings, if the pet stays in the detection zone, the base goes into safety mode.
The pet has to go out of the detection zone so that the base goes off again.
How to change the working mode:
To change the working mode of the base, you have to open the bedplate of the base and put the button of mode
selection on the mode you want.
Button of mode selection

Position 1: spray only
Spray refill housing