Installing And Connecting The Extractor Hood - Dometic CK 2000 Instructions De Montage Et De Service

Installing and connecting the extractor hood

6 Installing and connecting the extractor
hood
6.1 Note on the installation position
!
WARNING!
• It is best to install the extractor hood above the cooking area and
integrate it into a wall-mounted cupboard, where possible.
• The distance between the gas hob flame and the extractor hood
must total at least 65 cm.
6.2 Opening the extractor hood
➤ Remove the two screws (fig. 2 1, page 4) from the cover (fig. 2 2, page 4) and
remove it.
The filter holder (fig. 3 2, page 4) and the device (fig. 3 1, page 4) are held
together by metal clips (fig. 3 3, page 4) on the two front corners.
➤ Unclip the filter holder by pulling the filter holder and the device apart at the
points marked.
➤ Remove the filter holder (fig. 4 1, page 5) at the points marked.
6.3 Connecting the power to the extractor hood
➤ Connect the extractor hood to the battery using the terminal at the rear of the
device; see fig. 5, page 5.
Connect the following wires: Red to red and black to black/blue.
6.4 Fastening the extractor hood in place
➤ Position the extractor hood under the wall-mounted cupboard and fasten it in
place using the four screws provided (fig. 6, page 6).
➤ Fit the filter holder and clip it into place.
➤ Fit the cover (fig. 7 2, page 6) and fasten it using the two screws (fig. 7 1,
page 6).
12
CK2000
EN