Technical Data - AEG HK634060XB Notice D'utilisation

Problem
There is a dark area on
the multiple zone.
The sensor fields become hot.
comes on.
and a number come on.
You can hear a constant beep
noise.
comes on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error

9. TECHNICAL DATA

9.1 Rating plate
Model HK634060XB
Typ 60 HAD 47 AO
Ser.Nr. .................
AEG
Possible cause
It is normal that there is a dark area
on the multiple zone.
The cookware is too large or you put
it too near to the controls.
Child Safety Device or Lock oper‐
ates.
There is an error in the hob.
The electrical connection is incor‐
rect.
The second phase of the power sup‐
ply is missing.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The information about
guarantee period and Authorised Service
Centres are in the guarantee booklet.
PNC 949 492 154 01
220 - 240 V 50 - 60 Hz
Made in: Romania
7.0 kW
Remedy
Put large cookware on the rear zones,
if possible.
Refer to "Daily use".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
Check if the hob is correctly connected
to the electrical supply. Remove the
fuse, wait one minute, and insert the
fuse again.
ENGLISH
comes
45