Connection To A Television - Denon DVD-1600 Mode D'emploi

Connection to a television

Although the audio on most DVDs is designed to be played through six speakers and this unit's factory settings assume this setup, the following
describes connections that allow you to enjoy sound through your television's speakers. To get the full benefit from the powerful 5.1-channel audio
found on DVDs, you should connect an amplifier and six speakers (
Before connection
≥Disconnect the AC mains lead.
≥Refer to the television's operating instructions.
Connection to AUDIO IN
also necessary (see left)
AUDIO VIDEO
IN IN
L
R
red white yellow
Audio/video cable (included)
CENTER
DIGITAL OUT
( PCM B TSTREAM )
OPTICAL
SUB
WOOFER
S VIDEO OUT terminal
The S-video terminal achieves a more vivid picture than the VIDEO
OUT terminal by separating the chrominance (C) and luminance (Y)
signals. (Actual results depend on the television.)
Connect Your Unit Directly To Your Television.
Do not connect the unit through your video cassette recorder
when setting up your home entertainment system, because
the picture may not be played correctly due to the copy guard.
4
SCART
S VIDEO
VCR
IN
S video cable
(not included)
21-pin SCART
cable
(not included)
red white yellow
5 1ch 2 h
AUDIO OUT AUD OUT
SURROUND FR NT
VI O S VIDEO
L
O T OUT
R R R
page 16).
AV1
AC IN
AV2
AC mains lead (included)
SCART terminal
≥To improve picture quality, you can change the video signal output
from the AV1 terminal from "Video" to either "S-Video" or "RGB" to
suit the type of television you are using (
Output).
≥You can also connect other equipment to AV2.
Video
cassette
This unit
recorder
AV1
AV2
page 18, Video—AV1
Satellite receiver
or decoder
SCART terminal
AV1 VCR
of television
AV2 TV