Speed Table; Technical Data; List Of Spare Parts T 10 Basic - IKA WERKE T 10 basic Mode D'emploi

Speed table

Note: The speed table was calculated on the basis of a dispersion
volume of 5 ml water using the dispersing tool S10N-5G.
With other combinations (dispersion tools; medium quantity and
medium viscosity) can result other number of revolutions values.
Adjusting wheel scale
No-load speed
Speed with
5 ml water
The speeds depend on the dispersing element used as well as the
viscosity and quantity of the medium. It may, therefore, change
over the course of a dispersing process if the viscosity of the liquid
changes.

Technical data

Speed range
Speed display
Speed variation on load change
Perm. ambient temperature
Perm. relative humidity
Perm. on time (drive unit)
Overload protection / blocking protected
Protection to DIN 60529
Power consumption
Power output
T10B 022005
1 2 3 4 5
8.000 9.500 11.500 14.500 20.500 30.000
7.900 9.400 11.350 14.450 20.450 29.900
1/min 8.000 - 30.000
(at nominal design voltage
and 50 Hz)
Scale
(see speed table)
% <6
°C 5 - 40
% 80
min max 10 ON
min. 5 OFF
locking bimetallic
switch; tempera
ture and power
sensitively
IP31
W 125
W 75
Voltage
Frequency
Noise (without dispersing element)
Dimension (W x D x H) drive
6
Dimension (W x D x H) clamp arm
Weight
Contamination level
Protection class
Overvoltage categorie
Operation at a terrestrial altitude
Spare parts list T 10 basic
Item Designation
1 Housing
2 Flange
3 Cover
4 PCB compl. with motor
5 Coupling
7 Rocker switch
8 Connection cable
9 Plastite 2,5 x 8
11 Rotary knob
13 Speed wheel
15 Front panel
3001 Motor
3002 Pressure ball
3003 Grooved ball bearing
3004 Snap ring
3005 Temperature switch
VAC 220 - 240
(nominal design voltage 230V)
or VAC 115
or VAC 100
Hz 50/60
dB(A) 70
mm 45x180x60
mm Ø8 / L95
kg 0,4
2
II
II
m max. 2000 above
sea level
17