Speed Table; Technical Data - IKA T 10 basic Mode D'emploi

Speed table

Note: The speed table was calculated on the basis of a dispersion
volume of 5 ml water using the dispersing tool S10N-5G.
With other combinations (dispersion tools; medium quantity and
medium viscosity) can result other number of revolutions values.
Adjusting wheel scale
No-load speed
Speed with
5 ml water
The speeds depend on the dispersing element used as well as the
viscosity and quantity of the medium. It may, therefore, change
over the course of a dispersing process if the viscosity of the liquid
changes.
012009
1 2 3 4 5
8.000 9.500 11.500 14.500 20.500
7.900 9.400 11.400 14.450 20.450

Technical data

Speed range
Speed display
6
30.000
Speed variation on load change
29.900
Perm. ambient temperature
Perm. relative humidity
Perm. on time (drive unit)
Overload protection / blocking protected
Protection to DIN EN 60529
Power consumption
Power output
Voltage
Frequency
Noise (without dispersing element)
Dimension (W x D x H) drive
Dimension clamp arm
Weight
Contamination level
Protection class
Overvoltage categorie
Operation at a terrestrial altitude
Subject to technical changes!
rpm 8.000 - 30.000
(at nominal design voltage
and 50 Hz)
Scale
(see speed table)
% <6
°C 5 - 40
% 80
min max 10 ON
min. 5 OFF
locking bimetallic
switch; tempera
ture and power
sensitively
IP30
W 125
W 75
VAC 220 - 240
(nominal design voltage 230V)
or VAC 115
or VAC 100
Hz 50/60
dB(A) 65
mm 46x57x201
mm Ø8 / L100
kg 0,4
2
II
II
m max. 2000 above
sea level
17