Error Correction; Maintenance; Note To The Tool Set; Accessories - IKA T 10 basic Mode D'emploi

Error correction

The equipment is appropriate for short-time duty (10 min ON / 5
min OFF), i.e. indicated fall times must be considered. During
neglect the equipment can switch off depending upon load by
temperature rise during the enterprise, since the drive is equipped
with an overload safety device, which switches the equipment off
with overload or temperature rise. If the equipment switched off
at the On-/ Off- switch. After an appropriate cooling time the
equipment can be restartet.
Note: The equipment does not restart it after responding the over-
load safety device automatically, must for cooling at the rocker
switch (1) be switched off.

Maintenance

Maintenance and Cleaning
Drive unit:
The drive unit is maintenance-free but not immune from wear. The
carbon brushes of the motor wear down over the time.
To clean the drive use only water with a detergent that contains
tensides, or use isopropylalcohol for stubborn soiling.
Dispersion tools:
Consider please the manuals associated to the dispersion tools.
Spare parts order
When ordering spare parts, please give:
- Machine type
- Manufacturing number, see type plate
- Item and designation of the spare part,
see www.ika.net, spare parts diagram and spare parts list
012009
For cleaning disconnect the main plug
Repair
In case of repair the device has to be cleaned and free from any
materials which may constitute a health hazard.
If you require servicing, return the appliance in its original packa-
ging. Storage packaging is not sufficient. Please also use suitable
transport packaging.

Note to the tool set

The provided assembly tools (flat key and shaft key, fig. 3) can be
used to disassemble and assemble the dispersing elements for
cleaning and maintenance. Take the information about the exactly
use of the operating instructions of the dispersion tools.

Accessories

• R 1825 Plate stand
• R 104 Stand
• R 182 Cross sleeve
• H 44 Cross sleeve
15